Mechanical Track bulldozer line slope angle can not be greater than 30 degrees vertical and horizontal can not be greater than 25 degrees, under normal circumstances, you should avoid large angle slope line, in particular to avoid the lateral line of wide-angle slope. If you must travel on steep slopes, then the driver should be selected after a certain amount of training or have experience, to prevent the accident.
When the hydraulic drive system bulldozer move forward on the steep downhill, you should select a low gear, the engine throttle lever position should be placed on a small opening, and should pay attention to control the total brake pedal to prevent slip car.
When the bulldozers move forward on the steep downhill, if you need to move, manipulate the process with the same general shift manipulation process. However, due to its own weight bulldozer on steep slopes can produce downward trend, so pull the brake lever and steering the whole time not too long used. If you pull the lever half of the trip, only the side of the steering clutch, bulldozers will be under the influence of its own weight, to the opposite side of the slow turn. This is the ground turned to the opposite effect, please pay attention to the operator.
没有评论:
发表评论