Mechanical Bulldozer Supplier

First, the use of Notes

1. After the first use of the new machine should be run-in phase, not directly put into use. In the "run-in" process, paying particular attention to lubrication and maintenance, and inspection instruments, found fault immediately removed.

2. When the ambient temperature is below 5 ℃, the cooling water should be heated to 80 ℃ and then added to the tank, Mechanical Bulldozer Supplier turn on the water until after the cut-out of the door and turn off, and then continue to fill.

3. diesel engine starting, warm-up operation must be no load, the oil does not reach the scope of work, do not start driving.

4. In the initial process:

Never pulled directly from the neutral position of the second gear or third gear, so as bulldozers starting speed is too large, causing excessive transmission components to withstand shock loads.

Before hanging files, do not pull the throttle lever maximum throttle position.

Each lever plates move position must be accurate, MYW Bulldozer complete, not suspended, so as not to slip the clutch friction plate, causing severe burns, wear and tear.

5. In the process of shifting with the advance and retreat:

When operated shift lever, should be riding the accelerator pedal, and then pull the shift lever.

Such as the need to shift from one gear to pull, the car is not running, can be pulled from the neutral position to a gear, then pulled the desired range.

If there is no special need to avoid high-speed pivot turn, in order to avoid serious wear and tear or other damage to the running system.

6. On the steep slope: